When a simple solution is obvious, go for it. Before heading to the drawing board, we would note the conditions outlined in the following paragraphs this would guide us in planning the width of face frame members that might need to be scribed. No carpet, no furniture, no existing built-ins: a clean space to check for plumb, level, and square. In an ideal world, we would start with an empty room. The same basic principles apply in such cases, but there are a few additional points to bear in mind. Note: In most real-life scenarios, we’re not just installing a single cabinet, as we did in the kitchen example I used for this post, but a bank of cabinets that are fastened together. Here I’ll outline a method for scribing a base cabinet to an adjacent wall and the floor. In a previous post I described a method for scribing applied drawer faces to fit their face frames. In these cases, it’s customary to handle the gaps between built-ins and their settings by scribing, a method of marking a built-in precisely so that it can be trimmed to conform to its context. But some historical styles call for minimal applied trim. A common way of handling these points of intersection between a cabinet and its surroundings is to cover them up with trim: Think cove moulding, quarter-round, shoe moulding, crown. You get the picture.ĭesigning built-ins is an art that takes contextual imperfections into account and makes dealing with them as easy as possible. Plaster walls are rarely flat drywall builds up at interior and exterior corners. Ceilings tend to sag toward the middle of their rooms floors usually do the same. Rooms are virtually never square, level, or plumb. A shopmade crown moulding scribed to the ceiling in an extreme case of “not-flat” ceiling
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |